Workbenches

  • Part Design – Body ( Active Body )

    What is a Body and How is it used in FreeCAD? The “Body” in FreeCAD is a type of container. Ideally it is contained within a Part but as of […]

  • Arch Wall Command

    The Arch Wall Command adds a wall object to your model. If a qualifying entity is selected ( wire, edge, line ) the wall command will construct the wall based […]

  • Arch Structure

    The Arch Structure Command adds a Structure object to your model. The structure is a component of the building.

  • Arch Reinforcement Bar

    The Arch Reinforcement Bar adds Re-Bar to a selected face, for use within the Arch Workbench. The Re-Bar tool is tightly integrated to Arch but it is in fact a distinct entity

  • Sketcher Slot

    The Sketcher Slot adds a slot to the Sketch using two endpoints. The second endpoint sets the length of the slot and the radius of the Slot ends.

  • Sketcher Point

    The Sketcher Point adds a single Point to the Sketch

  • Sketcher Line

    The Sketcher Line adds a single edge to the sketch using a Point to locate the beginning and ending vertices

  • Sketcher Arc

    The Sketcher Arc add an arc to the Sketch using on of two modes. The arc can be added using a center point to locate the arc and a rim […]

  • Sketcher Circle

    The Sketcher Circle adds a circle to the Sketch using on of two modes. The circle can be added using a center point to locate the circle and a rim […]

  • Draft – Measure a Diameter

    Some of the Draft Measure tools can be a little evasive to understand. Draft diameter is one of them. In order to get a diameter you must pre-select a curve. […]

Terms and Conditions - Privacy Policy